Computer gong, is a Hong Kong side of the name, and later imported into the mainland Pearl River Delta, in fact, is the CNC milling machine, in this area of Guangdong, some people call "machining centers" (English name is Computerized Numerical Control Machine abbreviated as cnc) is a kind of automatic machine tool equipped with a program control system. The automated machine tool with a program control system. The control system is able to logically process the control code or other symbolic instructions with the provisions of the program, and will be decoded, so that the machine tool action and processing parts. It is also called CNC or numerical control machine.

What are the tricks of CNC programming when machining parts for Shanghai machining center manufacturers?

1. The speed of the white steel cutter should not be too fast.

2. Copper work roughing less with white steel cutter, more fly cutter or alloy cutter.

3. When the workpiece is too high, it should be layered with different lengths of knives to open the roughing.

4. After roughing with a large knife, a small knife should be used to remove the residual material, to ensure that the residual amount of the same before the light knife.

5. apply flat bottom knife processing, less use of ball knife processing, in order to reduce processing time.

6. when the copper workers clear the corner, first check the corner R size, and then determine how big the ball knife.

7. The four corners of the calibration plane should be gong flat.

8. Where the skew is an integer, the skew cutter should be used to process, such as pipe bits.

9. Before doing each process, think about the remaining margin after processing the previous process to avoid empty knife or processing too much and popping the knife.

10. Try to take simple cutter paths, such as profile, groove, single-sided, and less wrap-around and equal height.

11. When taking WCUT, don't take ROUGH if you can take FINISH. 12.

12. When profile light knife, first rough light, then fine light, when the workpiece is too high, first light edge, then light bottom.

13. Reasonably set the tolerance to balance the machining accuracy and computer calculation time. When roughing, the tolerance is set to 1/5 of the allowance, and the tolerance is set to 0.01 when light cutter is used.

14. Do a little more process to reduce the time of empty knife. Do more thinking to reduce the chance of error. Do more auxiliary lines and surfaces to improve machining conditions. 15.

15. Establish a sense of responsibility, double-check each parameter to avoid rework.

16. Study hard, think well, and keep improving.